NexGen Cruciate Retaining
NexGen® Complete Knee Solution Cruciate Retaining (CR)
The NexGen CR Femoral Component is intended for patients who, in the physician's judgement, have good bone stock and whose ligaments provide adequate mediolateral, anteroposterior, and varus/valgus stability. The NexGen CR Femoral Component offers true physician choice and patient specificity with left and right configurations in up to eight sizes, covering most indications. Options include porous fiber metal, PMMA precoat, and non-coated versions. Read more >
NexGen® Complete Knee Solution Cruciate Retaining Augmentable (CRA)
The NexGen CRA Femoral Component is intended for patients who, in the surgeon's judgement, have adequate mediolateral, anteroposterior, and varus/valgus ligament stability, yet require augmentation and/or stem extensions due to inadequate bone stock. The NexGen CRA Femoral Component is available with a PMMA precoat surface. This device is for cemented use only. Read more >
NexGen® CR-Flex Fixed Bearing Knee
The specific demands of the CR surgion
Specifically designed for the CR surgeon, the CR-Flex Knee represents an enhancement of the highly successful NexGen CR Knee. It's a good choice for CR patients because it offers new design elements that address not only high flexion, but many of the important issues faced by CR surgeons. For example, consider the knee that is tight in flexion and acceptable in extension. CR-Flex offers Minus size femoral components which are 2mm smaller in the A/P dimension. Without removing additional bone, the Minus size options help the CR surgeon balance the flexion and extension gaps. Read more >
NexGen Posterior Stabilized
NexGen® Complete Knee Solution Legacy Knee Posterior Stabilized (LPS)
The NexGen Legacy LPS Femoral Component is intended for patients who, in the surgeon's judgement, have adequate bone stock and varus/valgus stability, and/or when the surgeon elects to substitute for the posterior cruciate ligament. Fixation options include porous fiber metal, PMMA precoat and non-coated versions. Read more >
NexGen® LPS-Flex Fixed Bearing Knee
For patients with the ability and desire to perform high-flexion activities, implant design should not limit postoperative range of motion. The NexGen LPS-Flex Fixed Knee is designed to accommodate resumption of high-flexion daily activities. Attention to patient selection, surgical technique, implant size, and rehabilitation can help enhance the chances for success. Many activities of daily living require flexion beyond 120 degrees. Consider climbing stairs (75-140 degrees), sitting in a chair and standing up again (90-130 degrees),or squatting (130-150 degrees).1 The LPS-Flex Fixed Knee extends the NexGen Complete Knee Solution to patients capable of up to 155 degrees of active flexion. Read more >
NexGen Mobile Bearing
NexGen® LPS-Flex Mobile Bearing Knees
Designed for safe high flexion
Options for surgeons. Options for patients. The NexGen LPS-Flex Mobile and LPS-Mobile Bearing Knees provide options that allow the surgeon to select components based on the patient’s willingness and ability to achieve high flexion. Specific design features help to maintain adequate tibiofemoral contact during high flexion and provide greater clearance for the patellar tendon. Read more >
NexGen® CR-Flex Mobile
The NexGen CR-Flex Mobile Knee provide options that allow the surgeon to select components based on the patient’s willingness and ability to achieve high flexion. Specific design features help to maintain adequate tibiofemoral contact during high flexion and provide greater clearance for the patellar tendon. Tibia design is innovative and the solution for an minimal invasive approach. Read more >